Limited Edition Chromatic Tungsten 3.2mm Break-off Points for X10 & Pandarus
Limited Edition Chromatic Tungsten 3.2mm Break-off Points for X10 & Pandarus
Limited-edition chromatic (oil-slick / rainbow) 97% tungsten break-off points from Shore Shot. Same point you use for Easton X10 work, with a titanium-plated chromatic finish that is only in stock for a short run. Sold by the dozen.
Fit
Easton X10
Easton X10 ProTour
Pandarus CA320-XT
Zone Podium X A/C, Arena, and Speed X 3.2
Other shafts that take a 3.2 mm / 0.125" OD tungsten point
This listing
120 grain start weight
2 break-offs: 110 gr and 100 gr
12 matched points
Weight tolerance ±0.5 gr each, ±0.3 gr per dozen
97% tungsten
Titanium plating
Glue cutout under the head
6 glue grooves on the shank
Color will wear with use. Do not shoot into anything harder than a target bale.
Why tungsten + titanium plating
Tungsten keeps the point short for the grain weight, which helps FOC and wind drift at 70 m and 50 m. The titanium plating improves surface wear, fretting, and galling compared with raw tungsten.
Records shot with Shore Shot tungsten points
Individual Paralympic gold
Men’s recurve double 70 m 1,367
WHY Titanium Plating?
Reasons to implement a titanium electroplating process include enhancing the metal's ability to resist surface fatigue and fretting and anti-galling properties. Titanium substrate plating can also be used to improve the following scenarios: Corrosion resistance in hot acidic environments.
WARNING: cancer and reproductive harm - www.P65Warnings.ca.gov
*Color may ware after use
*Hitting objects other then target bales may cause point damage or breaks
*Reminder, EU customers will be responsible for paying VAT on pickup.
*Purchases outside of the United States may be subject to local taxes on delivery or additional shipping costs
Recommended Point Installation Method
(Tool Required: A butane or propane torch with small flame, pliers, cleaning materials noted below, and recommended hot melt (CDM Flitemate Hot Melt or Shop Stick)
Cut arrow shaft on high speed arrow saw and deburr the inside of shaft, removing no more then 1/4” of aluminum shaft wall
Clean the inside of the shaft (about 2” in) with 91% isopropyl alcohol
Heat hot melt in a gas flame and apply a ring of hot melt around and inside the open end of the shaft (Never Apply Heat Or Flame To The Shaft)
With your small set of pliers, grasp the point and coat the shank end of the point with hot melt that was headed by your hot flame (get hot melt soft not liquid)
Hold the point in your piers with the hot melt applied into the flame again, this time let it liquefy (MAX 3-4 Seconds Do Not Overheat the Point) Serious damage to the shaft or point could occur
Put point into shaft with a twisting motion. Quickly reheat THE POINT ONLY IF NEEDED to get in fully into the shaft. Whip excess glue with a paper towel
Stand the shaft on the point end making sure the point is completely seated in the shaft and allow it to cool before touching our shooting, DO NOT use water to cool the shaft and point
Adjusting Point Weight
Required Tools: 2 Small Pliers and Safety Glasses
Only applies to 120 grain and 140 grain points
To remove 1st break-off (lose 10 grains) Use one pair of pliers to grasp the INNERMOST weight segment and with the other pair of pliers break off the outermost segment
To remove 1st and 2nd break-off (lose 20 grains) Use one pair of pliers to grasp the shank of the point and with the other pair of pliers break off both weight segments