Shore Shot Tungsten Points For Carbon Express Nano Pro RZ

Nano+Pro+RZ+April.jpg
processed_2a400300b7b6470aa4a4815b61b540ce.jpeg
Nano+Pro+RZ+April.jpg
processed_2a400300b7b6470aa4a4815b61b540ce.jpeg

Shore Shot Tungsten Points For Carbon Express Nano Pro RZ

$160.00

Shore Shot Tungsten Points For Nano Pro RZ are designed to increase the tunability and customization of your Nano Pro RZ arrows by offering three point weight sizes. This starts with the full 120 grain point. Then breaking off one break-off gives you a 110 grain point. Followed by breaking two break-offs off giving you a solid 100 grain point. This will maximize the tune ability of your arrows. By having tungsten points it allows the archer to drastically cut down the amount of shank in your arrow shaft.

Points Fit - Carbon Express Nano Pro RZ (450-350 Spine)

Shore Shot Archery’s Take on Tungsten Points

  • Available in one size (450-350 Spine)

  • Each point is individually weighted and packaged

  • Tungsten break-off point for Carbon Express Nano Pro RZ shafts

  • 120 to 100 grains (2 break-offs)

  • Color: Silver

  • Titanium plating

  • 6 Grooves to improve glue adhesion in arrow shaft

  • Glue Cutout Below Head of Point For Better Adhesion In Arrow Shaft

  • Sold as a 12 pack

  • Weight tolerance: ± 0.5 grains (Matched Per Dozen ± 0.3)

  • 97% Tungsten

  • Shank OD .124”

    **May fit 500 Spine but proceed at your own risk

Records

  • Mens Compound 50M World Record 719 out of 720 (4/18/2026 Gator Cup)

Size:
Quantity:
Add To Cart

*Reminder, EU customers will be responsible for paying VAT on pickup.

*Purchases outside of the United States may be subject to local taxes on delivery or additional shipping costs

Recommended Point Installation Method

(Tool Required: A butane or propane torch with small flame, pliers, cleaning materials noted below, and recommended hot melt (CDM Flitemate Hot Melt or Shop Stick)

  • Cut arrow shaft on high speed arrow saw and deburr the inside of shaft, removing no more then 1/4” of aluminum shaft wall

  • Clean the inside of the shaft (about 2” in) with 91% isopropyl alcohol

  • Heat hot melt in a gas flame and apply a ring of hot melt around and inside the open end of the shaft (Never Apply Heat Or Flame To The Shaft)

  • With your small set of pliers, grasp the point and coat the shank end of the point with hot melt that was headed by your hot flame (get hot melt soft not liquid)

  • Hold the point in your piers with the hot melt applied into the flame again, this time let it liquefy (MAX 3-4 Seconds Do Not Overheat the Point) Serious damage to the shaft or point could occur

  • Put point into shaft with a twisting motion. Quickly reheat THE POINT ONLY IF NEEDED to get in fully into the shaft. Whip excess glue with a paper towel

  • Stand the shaft on the point end making sure the point is completely seated in the shaft and allow it to cool before touching our shooting, DO NOT use water to cool the shaft and point