Tungsten Tuning Points For Easton X10™ & X10™ ProTour Arrow Shafts
Tungsten Tuning Points For Easton X10™ & X10™ ProTour Arrow Shafts
Shore Shot Archery Tungsten Tuning Points are for archers who want to experiment to find the optimal point weight for their arrow shafts
Points Fit - Easton X10™ and Easton X10™ ProTour
Available in three different tuning set layouts:
Super Heavy Tuning Package (Great for Compound Archers)
1 Dozen Points (6 )120gr. points and (6) 140gr. points
120gr. points break-off to 110, and 100 grains)
140gr. points (break-off to 130, and 120 grains)
Heavy Tuning Package (Great for Recurve and Compound Archers)
1 Dozen Points (4 )100gr. points, (4) 120gr. points, and (4) 140gr. points
100gr. points (No break-offs)
120gr. points break-off to 110, and 100 grains)
140gr. points (break-off to 130, and 120 grains)
Light Tuning Package (Great for Recurve Archers)
1 Dozen Points (4 )90gr. points, (4) 100gr. points, and (4) 120gr. points
90gr. points (break-off to 80, 70, and 60 grains)
100gr. points (No break-offs)
120gr. points (break-off to 110, and 100 grains)
Additional Information
COLORS MAY VARY
Titanium Plating
Glue Cutout below head of point ( Allows for better fitment into arrow shaft)
Glue Grooves ( For better adhesion)
Sold in matched set of 1 dozen
Weight tolerance ±0.5 grains per dozen
97% Tungsten
OD .125”
Records
Men’s Individual Olympic Silver Medal 2024
Individual Paralympic Gold Medal 2020
Mens Recurve Double 70M 1, 367
WHY Titanium Plating? Reasons to implement a titanium electroplating process include enhancing the metal's ability to resist surface fatigue and fretting and anti-galling properties. Titanium substrate plating can also be used to improve the following scenarios: Corrosion resistance in hot acidic environments. WARNING: cancer and reproductive harm - www.P65Warnings.ca.gov*Color may ware after extensive use
*Hitting objects other then target bales may cause point damage or breaks
*Reminder, EU customers will be responsible for paying VAT on pickup.
*Purchases outside of the United States may be subject to local taxes on delivery or additional shipping costs
Recommended Point Installation Method
(Tool Required: A butane or propane torch with small flame, pliers, cleaning materials noted below, and recommended hot melt (CDM Flitemate Hot Melt or Shop Stick)
Cut arrow shaft on high speed arrow saw and deburr the inside of shaft, removing no more then 1/4” of aluminum shaft wall
Clean the inside of the shaft (about 2” in) with 91% isopropyl alcohol
Heat hot melt in a gas flame and apply a ring of hot melt around and inside the open end of the shaft (Never Apply Heat Or Flame To The Shaft)
With your small set of pliers, grasp the point and coat the shank end of the point with hot melt that was headed by your hot flame (get hot melt soft not liquid)
Hold the point in your piers with the hot melt applied into the flame again, this time let it liquefy (MAX 3-4 Seconds Do Not Overheat the Point) Serious damage to the shaft or point could occur
Put point into shaft with a twisting motion. Quickly reheat THE POINT ONLY IF NEEDED to get in fully into the shaft. Whip excess glue with a paper towel
Stand the shaft on the point end making sure the point is completely seated in the shaft and allow it to cool before touching our shooting, DO NOT use water to cool the shaft and point