Tungsten Points for Carbon Express Nano Pro RZ
Tungsten Points for Carbon Express Nano Pro RZ
Shore Shot Tungsten Points For Nano Pro RZ are designed to increase the tunability and customization of your Nano Pro RZ arrows by offering three point weight sizes. This starts with the full 120 grain point. Then breaking off one break-off gives you a 110 grain point. Followed by breaking two break-offs off giving you a solid 100 grain point. This will maximize the tune ability of your arrows. By having tungsten points it allows the archer to drastically cut down the amount of shank in your arrow shaft.
Fit
Nano Pro RZ #1 — 650–500 spine
Nano Pro RZ #2 — 450–350 spine
Not for Nano Pro X-TREME. That is a separate listing.
This point
120 gr start
Break-offs to 110 gr and 100 gr
Color: silver
Titanium plating
Glue cutout + 6 grooves
Shank OD 0.124"
Dozen match ±0.3 gr; singles ±0.5 gr
Record
Men’s compound 50 m 719/720, Gator Cup, 18 Apr 2026 — shot with Shore Shot tungsten.
Install
Hot melt
*Reminder, EU customers will be responsible for paying VAT on pickup.
*Purchases outside of the United States may be subject to local taxes on delivery or additional shipping costs
Recommended Point Installation Method
(Tool Required: A butane or propane torch with small flame, pliers, cleaning materials noted below, and recommended hot melt (CDM Flitemate Hot Melt or Shop Stick)
Cut arrow shaft on high speed arrow saw and deburr the inside of shaft, removing no more then 1/4” of aluminum shaft wall
Clean the inside of the shaft (about 2” in) with 91% isopropyl alcohol
Heat hot melt in a gas flame and apply a ring of hot melt around and inside the open end of the shaft (Never Apply Heat Or Flame To The Shaft)
With your small set of pliers, grasp the point and coat the shank end of the point with hot melt that was headed by your hot flame (get hot melt soft not liquid)
Hold the point in your piers with the hot melt applied into the flame again, this time let it liquefy (MAX 3-4 Seconds Do Not Overheat the Point) Serious damage to the shaft or point could occur
Put point into shaft with a twisting motion. Quickly reheat THE POINT ONLY IF NEEDED to get in fully into the shaft. Whip excess glue with a paper towel
Stand the shaft on the point end making sure the point is completely seated in the shaft and allow it to cool before touching our shooting, DO NOT use water to cool the shaft and point